Synchronous reset-priority RS-trigger

		`\| Vectorized \|`
`in the palette`	`on the schematic`	`\| Vectorized \|`

The block implements a synchronous reset-priority RS-trigger, i.e. at the time of synchronization, the block works similarly to the reset-priority RS-trigger:

where y(t) is the output signal of the block, y(t – Δt) is the value of the output signal at the previous time step of integration, x_S(t), x_R(t) is the first and third input signals of the block (from English Set and Reset).

Otherwise, the block saves the previous output state regardless of the values at the R and S inputs.

The sync moment is determined depending on the type of synchronizing input C:

by the front – when changing the value at the synchronizing input from 0 to 1;
by the drop – when changing the value at the synchronizing input from 1 to 0;
by the front and drop – in case of any change in the value at the synchronizing input;
by level – when supplying a logical unit to the synchronizing input (at each step of integration).

Input ports

S – the input port for setting the trigger;
C – the input synchronization port;
R – the input port for resetting the trigger.

Output ports

out – trigger output port;
Yinv – an inverse output port (optionally included in the block properties).

Properties

Synchronization input type – condition of triggering the synchronization input;
Initial conditions – initial value of the output;
Add inverse output – indicates the presence of an inverse output.

Parameters

none